Use and Care Manual

Close the tank drain valve (J) by turning in a clockwise

direction.

Plug in the power cord (C).

Turn the ON/OFF switch (F) to the ON position.

Adjust the regulated pressure gauge (B) to the working

pressure of the tool.

Turn the ON/OFF switch (F) to the OFF position.

Unplug the power cord (C).

Reduce the pressure in the tank through the outlet hose.

You can also pull the pressure relief valve ring (D) and keep

it open to relieve pressure in the tank.

Tip the air compressor (if necessary for your model) so the

air tank drain valve (J) is at the bottom of the tank. Then

open the tank drain valve (J) to allow moisture to drain from

the tank.

MOC.SLOOTYKSUH

.ecnatsissa rehtruf rof YKSUH-DH-888-1 tcatnoc esaelP

Secure the connections with sealant tape (O) to prevent

air leaks.

Attach the end of the air hose (K) into the connector

of the quick coupler (I).

If using the inﬂation needle (N) or tapered nozzle (P), attach the

adaptor (L) into air hose (K) ﬁrstly, then connect them with the

adaptor (L).

If using a tire chuck (M), connect it directly to the air hose (K).

Secure connections with sealant tape (O) if necessary.