Use and Care Manual

1
Air Grease Gun
Model No. CAT820
Table of Contents
z Specifications
z General Safety Information
z Features & Operation
z Maintenance
z Parts List
z Warranty
Specifications:
Shot: …………………………….………………Continuous
Pump Ratio: ……………..…….……………………… 40:1
Max. Grease Pressure: ………..……. 6,000 PSI@150psi
Grease Capacity: ………….……14oz. Cartridges or Bulk
Overall Length with Flexible Hose: ..………...…….. 20.1”
Weight: …………………………………….. about 3.16 lbs
Air Pressure Range: ........…………..………. 60 - 150 PSI
Recommended Air Pressure: ........................ 70 - 90 PSI
Avg. Air Consumption: ………………………….. 2.8 CFM
Recommended Hose Size: ……………………… 3/8" I.D.
Air Inlet: ………………………………….…... 1/4" NPT (M)
General Safety Information
Read Operating Instructions
Always become familiar with all the instructions and
warnings before operating any pneumatic tool.
Always Wear Approved Eye protection
Impact resistant eye protection should meet or exceed
the standards as set forth in the United States ANSI
Z87.1, Occupational and Educational Eye and Face
Protection. Look for the marking Z87.1 on your eye
protection to insure that it is an approved style. For
further information, ANSI Z87.1. Occupational and
Educational Eye and Face Protection, is available from
the American National Standards Institute, Inc., 11 West
42
nd
Street, New York, NY10036.
Hearing Protection is Recommended
Hearing protection should be used when the noise level
exposure equals or exceeds an 8 hour time-weighted
average sound level of 85dBA. Process noises,
reflective surfaces, other tools being operated nearby,
all add to the noise level present in your work area. If
you are unable to determine your noise level exposure,
we recommend the use of hearing protection.
Description
The Husky model no. CAT820 Air Grease Gun is designed for
lubricating automobiles, trailers, boats, light duty machinery
and farm equipment. Fully automatic motor, cycles continuous
grease shot operation when the trigger is depressed. High
pressure performance with 60 to 150 PSI generated at the
compressor allows the tool to deliver 2,400 to 6,000 PSI (40:1
ratio) of pressure into the desired fitting.
Avoid Prolonged Exposure to Vibration
Pneumatic tools can vibrate during use. Prolonged
exposure to vibration or very repetitive hand and arm
movements can cause injury. Stop using any tool if
discomfort, tingling feeling or pain occurs. You should
consult your physician before resuming use of the tool.
150 PSIG Maximum
Husky tools are designed to operate at an air pressure
of 150 pounds per square inch gauge pressure (150
PSIG) maximum, at the tool. Use of higher air pressure
can, and may cause injury. Also use of higher air
pressure places the internal components under loads
and stresses they were not designed for, causing
premature tool failure. The air supply should be clean
and dry, preferably lubricated. For best results drain the
moisture from your compressor daily.
YOUR RISK FROM THESE EXPOSURES VARIES,
DEPENDING ON HOW OFTEN YOU DO THIS TYPE
OF WORK. TO REDUCE YOUR EXPOSURE TO
THESE CHEMICALS, WORK IN A WELL VENTILATED
AREA AND WORK WITH APPROVED SAFETY
EQUIPMENT SUCH AS THOSE DUST MASKS THAT
ARE SPECIALLY DESIGNED TO FILTER OUT
MICROSCOPIC PARTICLES.
Operation & Parts Manual
Sold Exclusively at The Home Depot
2455 Paces Ferry Road, N.W. Atlanta, Georgia 30339