Instructions / Assembly
How to Use the Drain Cleaning Bladder
Priming the bladder:
1. Attach the drain clening bladder to a garden hose connected to a cold faucet. DO NOT USE hot water.
2. Feed the drain cleaning bladder into the drain pipe a minimum of 6 inch.
3. Turn on the cold (not hot) water slowly to full pressure. Hold the hose attached to the drain cleaning bladder
firmly in place until the drain cleaning bladder expands to fit snugly against the wall of the drain pipe.
Turn off cold water ince bladder has fully inflated. Repeat this step until snug fit is obtained.
Once primed, follow these instructions for best results:
4. Insert the drain cleaning bladder into the drain pipe until you reach the clog. Drain bladder MUST be inserted
completely into the drain pipe a minimum of 6 inch.
5. Turn on the cold (not hot) slowly to full pressure. Hold the hose attached to the cleaning bladder firmly in place
until the drain cleaning bladder expands to fit snugly against the wall of the drain pipe.
6. Once fully inflated, water will be forced out the end of the drain cleaning bladder to put pressure on the clog and
push it through the drain pipe.
7. Do not leave the bladder unattended while water is running. If water begins to back up, immediately shut the water off.
8. Once the clog is cleared, turn the water off and wait until the drain cleaning bladder is fully deflated
before removing from the drain pipe.
9. Disconnect the drain cleaning bladder from the garden hose, rinse with water and dry as needed.
Store the Drain Bladder in A Cool, Dark, Dry Place.
• Keep drain cleaning bladder away from children.
• DO NOT use drain cleaning bladder with hot water.
• DO NOT use with water pressure above 80 psi. Excessive pressure may cause the drain cleaning bladder to burst.
• DO NOT use in toilet fixtures. The drain cleaning bladder could damage the porcelain.
• DO NOT use after chemicals have been used to try to clear the clog. Residual chemicals could cause injury.
• DO NOT leave bladder unattended while water is running, If the clog does not clear the water may start to back up and cause flooding.
• DO NOT inflate the drain cleaning bladder outside of the drain or use for anything other than its intended purpose.
• Always stand to the side of the drain cleaning bladder when in used in case the hose starts to back out of the drain.
WARNING
WARNING! NOT TO BE USED IN:
• Toilets
• Where chemicals are present