Instructions / Assembly

4
Assembly Instrucons
Note: Install into solid wood joists only. Brackets must be mounted perfectly in line and square to each other.
Make sure the lag bolts are ght against the joist but DO NOT over-ghten the lag bolts. If they are over-
ghtened, the bolt could snap or the hole may be stripped.
Step 2 - Install Ceiling Brackets (A)
Locate and mark the center of ceiling joist with a pencil.
Use a stud nder to locate the joists if ceiling is nished
with drywall. Use Ceiling Angle Bracket as a template to
mark the two end holes of the Ceiling Angle Bracket on
the center line of the joist using a pencil. Drill pilot holes
using power drill with 7/32” drill bit to the marked
locaons.
✓
Depending on the ceiling rack orientaon preference,
measure 32 or 96” from the installed ceiling angle
bracket to determine the locaon of the second
ceiling angle bracket along the same joist. Must be
measured from the same end of the bracket. Repeat
the steps to install the second ceiling angle bracket in
the same orientaon as the rst.
Install Ceiling Angle Bracket (A) into marked joist using
two Lag Bolts (K) and two Large Washers (O) with a
1/2” socket wrench. The Lag Bolts should be installed
into the two end holes of the Ceiling Angle Brackets.
X
X
A
A
96”
For the second set of brackets, depending on prefered
orientaon, measure 32” or 96” from edge of installed
ceiling angle bracket to the other locaon for the
next bracket on the other joist. The bracket should be
installed in the same orientaon and must measure
32” or 96” from same edge of each bracket. Repeat the
steps to install the second set of ceiling angle brackets
in the same orientaon.
Note: If spacing in joists do not match up to the desired
assembled size and direcon you will need to install an
addional joists to accommodate, see page 3 for opons.
Must measure 32” or 96” from same end of each
bracket.
Must measure 32” or 96” from same edge of each
bracket.
96”
32”
32”