Instructions / Assembly

7
Assembly Instrucons
Step 7 - Install Beam Assemblies
Install one beam assembly by aaching both ends of the beam into the boom slots of each post. Use a rubber
mallet to lightly tap down on each end of the beam to properly seat the beam clips into the tapered ends of the slot.
Bolt together by using one Hex Bolt (L), one Lock Nut (M) and two Small Washers (N) per side into the lined up holes
of the beam and post. Repeat step to install the other beam assembly to other posts assemblies.
Step 6 - Assemble Le and Right Beams (E & F)
Bolt together one Le Beam (E) and one Right Beam (F) using four Hex Bolts (L), four Lock Nuts (M) and eight Small
Washers (N). Repeat steps to assemble the other Le and Right Beam.
✓
E
F
F
E
Tap down lightly on beam with
rubber mallet to seat the beam clips
into the tapered ends of the slots.
✓
G
✓
Step 8 - Install Center Support (G)
Bolt the Center Support (G) into the two holes found in the middle of each beam assembly using two Hex Bolts (L),
two Lock Nuts (M) and four Small Washers (N) per side.
G