Instructions / Assembly

8
Assembly Instrucons
I
I
J
J
Step 10 - Install Wire Decking (I & J)
Place the End Wire Decks (I) on the ends of the beams with the notched corners facing the end corners of the posts.
Next place two Center Wire Decks (J) between the previously installed end wire decks.
Step 9 - Install Cross Supports (H)
Assemble the six Cross Supports (H) by placing the rivets located on both ends of the cross support into the
triangular holes located on the top ledge of both beam assemblies.
H
H
✓
STEP 11 - Final Inspecon
Check each beam and post connecon to be sure that the
beams are properly seated and brackets are rmly connected
to the overhead joists. Make sure all bolts and nuts are
properly ghtened. It is recommended to periodically repeat
this inspecon process to ensure safety. Retain this manual for
future use.
✓
Note: Be sure the
notched ends on the
End Wire Deck (I) are
installed facing the posts.
I