Use and Care Manual

15
HUSKYTOOLS.COM
Please contact 1-888-43-HUSKY for further assistance.
pts-205109-051012, pts-2053019-053012, pts-206067-060612
Changing
WARNING: Drain tank to release
air pressure before removing the
oil ll cap or oil drain plug.
CAUTION: Overlling with
oil will cause premature air
compressor failure. Do not
overll.
1. Remove the oil ll plug (L).
2. Remove the oil drain plug (M) and drain
oil into a suitable container.
3. Replace the oil drain plug (M) and
tighten securely
4. Slowly add compressor oil until it reaches
the middle of the sight glass (N).
2
Air Filter
WARNING: Hot surfaces. Risk
of burn. Compressor heads are
exposed when lter cover is
removed. Allow compressor to
cool prior to servicing.
CAUTION: Keep the air lter
clean at all times. Do not operate
the air compressor with the air
lter removed.
A dirty air lter will not allow the air
compressor to operate at full capacity. Keep
the air lter clean at all times.
1. Remove the air lter cover.
2. Remove the air lter from lter cover.
4. Place new air lter into lter cover.
5. Replace air lter cover to pump.
3
BELT GUARD – REMOVAL
1. Turn air compressor off, lock out
the power supply, and relieve all air
pressure from the air tank.
2. Remove the 4 quarter turn fasteners
from the belt guard. The front belt guard
can now be lifted up and away from unit.
Maintenance (continued)
FIGURE 6
L
N
M
NOTE: When lling the crankcase, the
oil ows very slowly into the pump. If the
oil is added too quickly, it will overow
and appear to be full.
5. Replace oil ll plug (L) and tighten securely.