Use and Care Manual

6
Safety Information (continued)
ELECTRICAL SAFETY (SPEED AND WIRING)
□ The no-load speed of this product is approximately
775 rpm. This speed is not constant and decreases
under a load or with lower voltage.
□ For voltage, the wiring in a shop is as important as
the motor’s horsepower rating. A line intended only
for lights cannot properly carry a power tool motor.
Wire that is heavy enough for a short distance will
be too light for a greater distance. A line that can
support one power tool may not be able to support
two or three products.
ELECTRICAL SAFETY (GROUNDING
INSTRUCTIONS)
□ This product must be connected to a grounded,
metallic, permanent wiring system, or an equipment-
grounding terminal or lead on the product.