Owner's Manual

WARNING Designed for use at motor fuel dispensing facilities only.
NOTE: Always adhere to installation / usage instructions and warning. Improper use may result in injury, damage or
hazardous spill.
1. Turn off dispenser and relieve line pressure.
2. Use pipe thread sealant (not Teon tape) approved for gasoline on the male
threads of hose section.
3. Install at either the nozzle or dispenser.
4. Tighten approximately 1 or 2 turns past hand tight - do not overtighten.
5. Pressurize system and visually inspect for leaks.
VERIFY SMOOTH ROTATION OF ALL SWIVEL JOINTS AFTER INSTALLATION.
DO NOT OVERTIGHTEN
Husky Corporation • 2325 Husky Way • Pacic, MO 63069 • Phone: [phone] • Fax: [phone] • www.husky.com
Page 1 009056-12 9/2010
MADE IN THE USA
INSTALLATION INSTRUCTIONS
IF DRIVE OFF OCCURS
Daily
• Check for leaks / stains
• Check for damage
• Check for smooth rotation of
all swivel joints.
Monthly
• Measure gap at joint - a credit
card should not t in the gap
(0.03 in / 0.76 mm).
• Check "remove after" date.
Annually
• Check for electrical
conductivity.
• All drive aways, maintenance and
inspection activities must be logged
using the serial number of the
individual product.
• Apply city, state, or federal testing
regulations as appropriate.
ANY TEST / INSPECTION
FAILURE REQUIRES IMMEDIATE
EQUIPMENT REPLACEMENT OR
REMOVAL FROM SERVICE.
Conventional / High-Flow / Diesel Swivels
Recommended Installation, Maintenance
and Inspection Instructions
SWIVELS
TESTING / MAINTENANCE / INSPECTION
Model #
0087
0087W
0095
0350
0350W
0352
0352W
0355
0356
2272
2950
3395
3895
3898
4860
5235
5240
5265
5266
• Turn off dispenser and relieve line pressure.
• Inspect the entire dispensing system for damage.
• Check for leaks.
• Check for smooth rotation of all swivel joints.
• Measure gap at joint - if a credit card ts in the gap (0.03 in / 0.76 mm) do not
reinstall.
• Check for electrical conductivity.