Use and Care Manual

ManualsBrandsHusky ManualsKitchenPneumatic 3-1/2 in. 21-Degree Full-Head Strip Framing Nailer

TROUBLESHOOTING

Stop using tool immediately if any of the following problems occur. Serious personal injury

could result. Any repairs or replacements must be done by a qualified service person or an

authorized service center.

WARNING:

Air leaking at trigger

valve area.

O-rings in trigger valve housing are

damaged

Replace o-rings. Check operation

of Work Contact Element(WCE)

Air leaking between

housing and nose.

Loose screws in housing

1.Damaged O-rings

2.Damaged to bumper

Tighten screws

1.Replace -rings

2.Replace bumper

Air leaking between

housing and cap.

1.Loose screws

2.Damaged gasket

1.Tighten screws

2.Replace gasket

1.Replace bumper

2.Clean drive channel

3.Clean magazine

4.Replace spring

5.Check fitting, hose, or compressor

6.Replace and lubricate -rings

7.Replace -rings

8.Tighten screws and fittings

9.Replace gasket

1.Worn bumper

2.Dirt in nose piece

3.Dirt or damage prevent fasteners or

pusher from moving freely in

magazine

4.Damaged pusher spring

5.Inadequate air flow to tool

6.Worn O-ring on piston or lack

of lubrication

7.Damaged O-ring on trigger valve

8.Air leaks

9.Cap seal leaking

Tool skips driving

fastener

PROBLEMS POSSIBLE CAUSE(S) CORRECTIVE ACTION

1.Lubricate nailer

2.Replace spring

3.Replace damaged internal parts

1.Tool not lubricated sufficiently

2.Broken spring in cylinder cap

3.Exhaust port in cap is blocked

Tool runs slow or has

loss of power

1.Replace guide

2.Use only recommended fasteners

3.Replace with undamaged fasteners

4.Tighten screws

5.Replace driver

1.Guide on driver is worn

2.Fasteners are not correct size

3.Fasteners are bent

4.Magazine or nose screws are loose

5.Driver is damaged

Fasteners are jammed

in tool

If within two years from the date of purchase, this Husky air tool product

fails due to a defect in materials or workmanship, please immediately

contact Product Support at (8am to 5pm EST, M-F,

except normal Holiday).Do not return the air tool to the store. Please be

prepared to send the product, postage prepaid, along with a copy of the

dated first owner purchase receipt with the toolmodelto: PRIME

GLOBAL PRODUCTS, INC. Address: Ball Ground, Ga 30107. A

defectiveproductwillbepromptlyreplacedwithanewoneof

equalorgreatervalue. Thiswarrantyexcludes

incidental/consequentialdamagesandfailuresduetomisuse,

abuseornormalwearandtear. Thiswarrantygivesyou

specific rights, and you may also have other rights, which vary, from

state to state. Please call for details.

1-866-676-8468

WARRANTY

2 YEARS LIMITED WARRANTY