Instructions / Assembly

Assembly Instructions
Thank You. We appreciate the trust and confidence you have placed in Husky through the purchase of this shelf storage rack.
Should you have any comments, damage, missing parts, or problems with this unit please contact our
Husky Manufacturing Facility at 773-475-3137 or [e-mail] and request Quality Service.
To obtain replacement parts please provide the following: Model Number, Part Number & Description, Location & Date Purchased.
To purchase additional Storage products please visit www.HomeDepot.com MADE IN CHINA
This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor
product performance, or a possible “tipping” safety hazard.
DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER ! DO NOT OVERLOAD.
Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf. Use care
and the proper attire when working with metal parts.
Figure 1
Beam
Bracket Tabs
Beam
End Frame Post
End Frame Post Slots
Plastic
Push Clip
Wire Deck Shelving
Figure 3 Figure 2
Tie Bar
Inside Bottom
Edge of Beam
Attach the beams to the welded end frame
posts (see figure 1) starting at the bottom level
by using both end frames to establish the left
and the right sides of the units.
After a beam has been placed in both end
frame posts slots, tap the beam down at both
ends with a rubber mallet to help drive the
beam bracket tabs into the slots to secure the
beam. Continue assembling each level from
bottom to top level (front and back).
If the beam bracket tabs become bent due to
mishandling. It may be necessary to adjust the
tabs back to their proper form.
Place a plastic push clip into the hole of the
beam end clip, then tap the plastic clip with a
mallet to drive it into the hole of the end frame
post to secure the beam to the end frame (see
figure 1).
The completed unit should have four (4) levels
evenly spaced for maximum stability.
Although the beams are adjustable in height,
it’s recommended to evenly space them so
that the stability of the unit is not compro-
mised.
Tie bars are used to assist with a heavy load.
Insert a tie bar in each level by aligning the
holes located on the ends of the tie bar, to the
holes located toward the center and on the in-
side bottom edge of the beams (see figure 2).
Use the nuts and bolts provided to properly
fasten.
Husky Bulk Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly. The rack
units can stand individually, or for greater stability, be joined together using the common post.
Individual beams can be adjusted without disturbing the beams in adjoining units.
These instructions should be followed exactly. All parts supplied must be used as shown. Any alteration or deviation from this
instruction sheet can result in unit failure.
After the unit is assembled, it must be placed on a level surface for safety, and optimal product performance.