Instructions / Assembly

ManualsBrandsHusky ManualsGarage Shelves & Racks77 in. W x 78 in. H x 24 in. D 4-Shelf Welded Steel Garage Storage Shelving Unit with Wire Deck in Red

Item Number: 1004171291

Model Number: ERZ782478W4R

4-LEVEL WELDED STEEL STORAGE RACK

77"W x 24"D x 78"H

Items you might find helpful

GUARANTEED FOREVER. If your Husky tool or storage

unit ever fails bring it back and we will replace it for free.

This full warranty gives you specific rights which vary from

state to state. If this product is defective contact the

manufacturer for repair or replacement parts.

Warranty

Contents

Description Quantity Part Number

A: frame 2 ERF7824-R

B: beam 8 ERB72-R

C: tie channel 12 ER-V4-TB-R

D: wire deck 4 RWD2472-BLK

E: plastic push clip 16 BBC.118B

Components

General Instructions

Assembly of this unit is done by fitting the brackets of the

beams into the slots of the post frames.

A rubber mallet should be used on the ledge of the beams

to properly seat the beam brackets. If a hammer is used

care should be taken to protect the beam surface to avoid

damage by using a protective cloth or block of wood.

The stepped surface of the beam ledge is the top, and

should face upwards. This is the surface that the wire deck

will rest on.

A bracket should engage and fit firmly into the tapered slot

of the post frame. This engagement is a tight swaged fit

and will apply resistance as it fully engages. A visual

inspection should be made to show that the bracket is

properly engaged in the slot.

After assembly re-check each beam for proper

engagement.

Safety Instructions

This unit should be placed on a level surface. Failure to

do so can result in poor product performance or create a

possible safety hazard.

This unit should be securely anchored to a wall or floor

with suitable fasteners, which are not included.

Do not use this unit for anything other than the

manufacture’s intended purpose.

DO NOT STAND ON ANY PART

OF THE UNIT, OR USE IT AS A

LADDER.

Use care when working with

metal parts. Wear gloves for

protection.

Evenly distribute the weight on each level and always

keep the heavier loads on the bottom.

A: frame

D: wire deck

B: beam

Rubber Mallet, Gloves

C: tie channel

E: plastic

push clip

V4tb

Summary of content (2 pages)

PAGE 1
Item Number: 1004171291 Model Number: ERZ782478W4R V4tb 4-LEVEL WELDED STEEL STORAGE RACK 77"W x 24"D x 78"H Warranty Items you might find helpful GUARANTEED FOREVER. If your Husky tool or storage unit ever fails bring it back and we will replace it for free. This full warranty gives you specific rights which vary from state to state. If this product is defective contact the manufacturer for repair or replacement parts.
PAGE 2
Assembly Instructions Attach the beams to the welded end frame posts (see figure 1) starting at the bottom level by using both end frames to establish the left and the right sides of the units. • After a beam has been placed in both end frame post slots, tap the beam down at both ends with a rubber mallet to help drive the beam bracket tabs into the slots to secure the beam. Continue assembling each level from bottom to top level (front and back).