Manualshelf

Instructions / Assembly

ManualsBrandsHusky ManualsGarage Shelves & Racks77 in. W x 78 in. H x 24 in. D 4-Shelf Welded Steel Garage Storage Shelving Unit with Wire Deck in Red
12
Item Number: 458-424
Model Number: ERZ782478W-4
FOUR-LEVEL STEEL BULK STORAGE RACK
Tools Required
GUARANTEED FOREVER. If your Husky tool or storage
unit ever fails bring it back and we will replace it for
free. This full warranty gives you specific rights which
vary from state to state. If this product is defective con-
tact the manufacturer for repair or replacement parts.
Warranty
Hammer or Rubber Mallet
Adjustable Wrench
Slotted Screwdriver
Contents
Description Quantity Part Number Size
A: beam
8 ERB72BLK 72”
B: frame 2 ERF7824BLK 24” x 78”
C: tie bar 4 ERTB24BLK 24”
D: wire deck
4 RWD2472SF 24” x 72”
E: fasteners 1 bag nuts (8) bolts (8)
F: push clips 16 ERPCLP
Components
A: beam
D: wire shelf
General Instructions
Assembly of this unit is done by fitting the brackets of
the beams into the slots of the post frames.
A rubber mallet should be used on the ledge of the
beams to properly seat the beam brackets..
The stepped surface of the beam ledge is the top, and
should face upwards. This is the surface that the wire
deck will rest on.
A bracket should engage and fit firmly into the tapered
slot of the post frame. This engagement is a tight
swaged fit and will apply resistance as it fully engages.
A visual inspection should be made to show that the
bracket is properly engaged in the slot.
If a hammer is used care should be taken to protect the
beam surface to avoid damage by using a protective
cloth or block of wood. After assembly re-check each
beam for proper engagement.
Safety Instructions
These units should be placed on a level surface. Fail-
ure to do so can result in poor product performance or
create a possible safety hazard.
This unit should be securely anchored to a wall or floor
with suitable fasteners, which are not included.
Do not use this unit for anything other than the manu-
facture’s intended purpose.
Do not stand on any part of the unit, or use it as a lad-
der.
Use care when working with metal parts.
* Evenly distribute the weight on each level and always
keep the heavier loads on the bottom.
B: frame
C: tie bar
F: push clip

Summary of content (2 pages)