Use and Care Manual

4
Safety Information (continued)
□ Wear safety glasses and use hearing protection when
operating the unit.
□ Do not stand on or use the unit as a hand hold.
□ Do not wear loose clothing or jewelry that will get caught in
the moving parts of the unit.
□ Keep fingers away from a running compressor; fast moving
and hot parts will cause injury and/or burns. Compressor
parts may be hot even if the unit is stopped.
□ Follow all local electrical and safety codes as well as in
the United States, the National Electrical Codes (NEC), and
Occupational Safety and Health Act (OSHA).
□ Avoid body contact with grounded surfaces such as pipes,
radiators, ranges, and refrigerators. There is an increased
risk of electric shock if your body is grounded.
□ Do not expose power equipment to rain or wet conditions.
Water entering the power equipment will increase the risk
of electric shock.
□ Replace damaged cords / wiring immediately. Damaged
cords / wiring increase the risk of electric shock.
□ Do not smoke when spraying paint, insecticides, or other
flammable substances.
□ Use a face mask / respirator when spraying and spray in a
well ventilated area to prevent health and fire hazards.
□ Do not direct paint or other sprayed material at the
compressor. Locate the compressor as far away from
the spraying area as possible to minimize overspray
accumulation on the compressor.
□ When spraying or cleaning with solvents or toxic
chemicals, follow the instructions provided by the chemical
manufacturer.
PERSONAL SAFETY
ELECTRICAL SAFETY
SPRAYING PRECAUTIONS
WARNING: Never operate the compressor without a
beltguard. This unit can start automatically without
warning. Personal injury or property damage could
occur from contact with moving parts.
WARNING: Improper electrical grounding can result in
electrical shock. The wiring should be done by a qualified
electrician.
WARNING: Do not spray flammable materials in the
vicinity of an open flame or near ignition sources
including the compressor unit.
CAUTION: Compressor parts may be hot even if the unit
is stopped.
CAUTION: Improper electrical installation of this
product may void its warranty. Have circuit wiring
performed by qualified personnel, such as a licensed
electrician who is familiar with the current national
and local electrical codes.