Use and Care Manual
6
Claw Hammer Safety Goggles
Phillips
Screwdriver
Flathead
Screwdriver
Measuring Tape
Adjustable
Wrenches (2)
Ratchet and
1/2in. Socket
1/4in. Socket
9/16in. Socket
Pipe Wrench
Hammer Drill
and Masonry
Bit
Voltage Meter Work Gloves
Concrete Wedge
Anchors
Vibration Isolation
Set (3 pads)
Strain Relief
Isolation Valve (3/4 in.) Nipple (3/4 in.)
It is extremely important to install the compressor in a clean,
well ventilated area where the surrounding air temperature
will not be more than 100°F. Provide a minimum clearance
of 18 in. between the compressor flywheel or fan and the
wall, and ensure clear access to the drain valve to facilitate
condensate drainage. Do not locate the compressor air inlet
near steam, paint spray, sandblast areas, or any other source of
contamination.
PLANNING INSTALLATION
TOOLS REQUIRED
HARDWARE REQUIRED (Not supplied with unit)
Pre-Installation
WARNING: Disconnect, tag, and lock out the power
source before attempting to install or relocate the
compressor.
IMPORTANT: This compressor is not intended for
outdoor installation.
NOTE: Hardware not shown to actual size.