Instructions / Assembly

Operation
Installing the drawers
□ Pull the slides and slide carrier out until fully extended.
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer.
□
□ Slowly push the drawer until it is fully closed to
engage the slide.
□ Open the drawer and close it to verify proper
operation.
Slightly insert one side and repeat for the other side.
3
2
Removing the drawers
□ Fully extend and empty the drawer.
□ Depending on the slide, either lift or lower the
release lever on both sides so the slides can ride over
the stops. Pull out to remove.
1
Locking and unlocking the unit
IMPORTANT : The drawers must be fully closed before
locking / unlocking the unit.
□
To lock the unit, insert the key (J) into the lock cylinder (K)
□
To unlock the unit, nsert the key (J) into the lock cylinder (K)
J
and turn it 1/4-turn to the left. Then remove the key.
and turn it 1/4-turn to the right. Then remove the key.
9
Lifting/Lowering extendable side table
4
□
Lift the extendable side table (S) to raise into position and
□
Lower the extendable side table (S) when not in use. Pull it and
insert it’s supporting leg into the holder (R). Make sure it is
it’s supporting leg up first and let it down slowly.
locked to the mechanism properly.
S
S
HUSKYTOOLS.COM
Pleas e contact 1-888-43-HUSK Y fo r furthe r assistanc.e