Instructions / Assembly

ManualsBrandsHusky ManualsTool Chest Combos52 in. 18-Drawer Tool Chest and Rolling Tool Cabinet Combo in Black

Pre assembly-

TOOLS REQUIRED

Phillips

screwdriver

Safety

goggles

10 mm

Wrench

13 mm

Wrench

HARDWARE INCLUDED

NOTE: Hardware not shown to actual size.

Part Description Quantity

Bolt M6x15L

BB Washer M8

Bolt M8x20L

Screw M4x8L

SPECIFICATIONS

Maximum capacity (chest drawer)

300 lbs.

Maximum capacity (cabinet drawer)

800 .lbs

Empty weight 374 lbs.

NOTE: Begin product assembly close to the final

intended location of your chest cabinet This/.

product is heavy and may be difficult to move

after assembly.

Summary of content (6 pages)

PAGE 1
Pre-assembly TOOLS REQUIRED Phillips screwdriver Safety goggles 10 mm Wrench 13 mm Wrench HARDWARE INCLUDED NOTE: Hardware not shown to actual size. AA BB CC Part Description AA Bolt M6x15L 6 BB Washer M8 24 CC Bolt M8x20L Screw M4x8L 24 8 DD Quantity SPECIFICATIONS Maximum capacity (chest drawer) 300 lbs. Maximum capacity (cabinet drawer) 800 lbs. Empty weight 374 lbs. NOTE: Begin product assembly close to the final intended location of your chest/cabinet.
PAGE 2
Pre-assembly (continued) PACKAGE CONTENTS M A J B L I C K D E G F H Part A Description Gas lift F Quantity Part Description 2 H Regular caster Quantity 2 I Drawer 18 B Top chest 1 C Bracket 2 J Lock 2 K Key (set) 2 L Husky badge 2 M Drawer Liner 19 D Side handle 1 E Rolling cabinet 1 F Swivel caster with brake 4 G Drawer slide (pair) 20 5 HUSKYTOOLS.COM Please contact 1-888-43-HUSKY for further assistance.
PAGE 3
Assembly 1 Attaching the side handle 2 Installing the casters □ Attach the side handle (D) to the rolling cabinet (E) using six bolts (AA). CAUTION: Do not over tighten the screws. NOTE: The holes in the cabinet are tapped and do not require nuts. □ Ensure all cabinet drawers are securely locked into place using the key lock on the rolling cabinet (E). □ Lay the rolling cabinet (E) on its back. Use the packaging material to protect the finish.
PAGE 4
Assembly (continued) 5 Installing the drawer liner □ Place the drawer liners (M) in appropriately sized drawers and the chest lid area to protect the surface. M 7 HUSKYTOOLS.COM Please contact 1-888-43-HUSKY for further assistance.
PAGE 5
Operation 1 Locking and unlocking the unit 2 Removing the drawers □ Fully extend and empty the drawer. □ Depending on the slide, either lift or lower the release lever on both sides so the slides can ride over the stops. Pull out to remove. IMPORTANT : The drawers must be fully closed before locking / unlocking the unit. □ □ □ □ Insert the key (K) and turn it fully to the left to lock. Remove the key (K). Insert the key (K) and turn it fully to the right to unlock. Remove the key (K).
PAGE 6
Maintenance 1 2 Maintaining the casters □ Grease the casters annually using high quality bearing grease. Care and Cleaning □ This steel product has been coated with industrial powder coating for a durable finish. □ To help protect the powder coated finish, do not allow harsh chemicals (oil, grease, or other chemical) to remain on the powder coating surface. □ Use a glass cleaner (Windex R or equivalent product) to clean and maintain all surfaces of powder coating.