Use and Care Manual

5 | DOC-585_EN REV05 ORIGINAL INSTRUCTIONS
4. INSTALLATION
3. MODEL
HUSKY PRO P20290NACCA NOTE
» In order to avoid overheating, we recommend 12 in / 30 cm clearance
on both sides and in front of the unit.
Air intake
Disposable lter bag
(optional)
Polyethylene
ultra-resistant canister
Machine washable
permanent lter
Sturdy / durable
handles
Stainless steel
latches
Brushed aluminium
cover
Heavy-duty
removable gasket
Internal controller
module with soft-start
and LED status indicator
Muer
(optional)
POWER UNIT
Fig. 1 Mounting the unit
The power unit must be installed in a ventilated area, easily accessible and away from any heat
source� It should also be close to an accessible electrical outlet�
1� Determine the location of the power unit on the wall; we recommend that the power
unit be fastened at 60” / 1,5 m from the ground in order for the dust canister to be readily
accessible; allow 12” / 30 cm clearance on all sides of the power unit� When possible, it
is advisable to install the power unit on a concrete wall in order to minimize the noise
caused by vibrations;
2� Gypsum wall:
• Prepare the wall by installing a plywood mounting board (not provided) 16” / 40 cm high
x 3/4” / 2 cm thick and wide enough to be screwed to at least 2 studs;
• Fasten the mounting bracket to the mounting board with the provided screws;
3� Concrete wall:
• Drill the holes with a concrete drill bit;
• Insert the provided wall anchors into the drilled holes;
• Fasten the mounting bracket to the mounting board with the provided screws into
the anchors;
NOTE
» You can still install a plywood mounting board (16” / 40 cm x 10” / 25
cm x 3/4” / 2 cm) if desired;
» You can use provided screws to x mounting board on the wall, but
cannot use them for installing the mounting bracket on the mounting
board because of their length. You need to use shorter screws (not
provided).
IMPORTANT
Always use the right type of screws for the surface you are working with (wood,
concrete, metal…)
4� Insert the power unit bracket into the mounting bracket (as shown in gure 1);
5� Insert the PVC pipe into the air intake coupling; DO NOT GLUE!
6� Connect the controller module to the low-voltage wire (see section 6);
7� Install the muer;
8� Connect the power unit directly to an electrical outlet�