Use and Care Manual

6 | DOC-585_EN REV05 ORIGINAL INSTRUCTIONS
6. LOW VOLTAGE WIRE CONNECTION
1. 2. 3.
Fig. 4 Low voltage wire connection
Before connecting the low-voltage wires, make sure that the power unit is disconnected from
the electrical outlet�
1� First, strip the low voltage wires approximately 3/8 in / 10 mm;
2� Crimp the connectors onto the wires in order to hook-up the system�
3� Insert the low-voltage wires into the power unit’s low voltage terminal� Slightly pull on
the low-voltage wires to verify that they are properly fastened to the terminal�
4� To remove the wires, gently pull the connector out of the socket�
7. SYSTEM OPERATING INSTRUCTIONS
You may vacuum a great variety of materials with your new system, wet or dry� Before each
use, you must check that the ltration system in the canister is set up for the type of material
you are planning to vacuum�
dry materials
The permanent lter must be installed for this type of material� To optimize the ltering
capacities of your system, the use of an optional ltration bag is recommended�
Fine dust, sludGy materials, etc.
The permanent lter must be installed for this type of material� Pull a paper protection lter
(sold separately) over the permanent lter�
liquids and damp materials
Take o the permanent lter and all paper lters and bags while vacuuming liquids�
Now your new system is ready to be used, here are some simple guidelines to follow when
using your power unit:
• Insert the exible hose in one of the wall or oor vacuum inlets installed in your home;
• If you use a hose tted with a switch on the handle, use the interrupter on the hose’s
handle to turn the power unit on/o�
5. FLEXIBLE HOSE WITH ERGONOMIC HANDLE
At Husky, we understand that your cleaning
experience with a central vacuum system begins
above all with the use of the exible hose and
accessories� This is why we oer products above
market standards, on top of having
incomparable advantages like the best warranty
in the industry�
Fig. 3 Low voltage technology exible hose
Your Husky exible hose comes with a uniquely designed ergonomic handle, which makes its
use pleasant and worry free�
In your Husky hose handle, you will nd the same quality, durability and solid design made
with rst-quality materials� The top-of-the-line nish of your Husky exible hose is perfectly
harmonized with a series of accessories chosen by Husky to make a perfect cleaning kit� The
performance, simplicity and durability are the three principles which led to the development
of your Husky accessory kit� We are convinced that your cleaning experience will be improved
by it�
The purpose of a muer is to reduce the sound
emitted by the system� To install the muer on
your power unit, follow these simple steps:
1� Turn o and unplug the unit;
2� Attach the 90° long metal elbow upwards
or downwards onto the central vacuum outlet
(silicone coupler);
3� Secure the muer onto the 90° long
metal elbow using the provided self-tapping
screw;
Fig. 2 Installing the muer
4� OPTIONAL - If you plan on exhausting the central vacuum outside, install more metal
piping starting from the other end of the muer�
NOTE
» The muer can be oriented in the direction of the exterior vent. The
90° elbow is not mandatory.
» In case of space restriction around the power unit install the muer
at any convenient distance screwing spare metal piping in place.
IMPORTANT
DO NOT use any plastic piping (e.g. PVC) along the full length of the central
vacuumexhaust piping.
MUFFLER