Use and Care Manual

Assembly

Assembling the air compressor unit

WARNING: Never use plastic (PVC) pipe for compressed

air. Serious injury or death could result.

WARNING: Never install a shut-off valve between the

compressor pump and the tank. Personal injury and /

or equipment damage may occur. Never use reducers in

discharge piping.

NOTE: Do not overtighten. Over the life of the unit, you will

clean or replace the ﬁ lter as needed.

This air compressor unit can be installed as part of an air

distribution system. Any tube, pipe, or hose used in an air

distribution system must have a pressure rating higher than

150 psi. The minimum recommended pipe size is 3/8 in. Using a

larger diameter pipe is always better.

Install a shut-off valve on the discharge port of the tank to control

the air ﬂ ow out of the tank. Locate the valve between the tank and

any piping system.

□ Screw the air ﬁ lter (B) onto the pump air intake.