Use and Care Manual

7 HUSKYTOOLS.COM

Please contact 1-888-43-HUSKY for further assistance.

Pre-Installation

PLANNING INSTALLATION

WARNING: Disconnect, tag, and lock out the power source

before attempting to install or relocate the compressor.

IMPORTANT: This compressor is not intended for outdoor

installation.

It is extremely important to install the compressor in a clean, well ventilated area where the surrounding air temperature will not be more

than 100°F. Provide a minimum clearance of 18 in. between the compressor ﬂ ywheel or fan and the wall, and ensure clear access to the

drain valve to facilitate condensate drainage. Do not locate the compressor air inlet near steam, paint spray, sandblast areas, or any other

source of contamination.

TOOLS REQUIRED

Claw hammer Safety goggles

Phillips

screwdriver

Flat blade

screwdriver

Measuring

tape

Adjustable

wrenches (2)

Ratchet and

1/2 in. socket

Pipe wrench

Hammer drill

and masonry

bit

Voltage meter Work gloves

HARDWARE REQUIRED

NOTE: Hardware not shown to actual size.

Concrete wedge

anchors

Vibration isolation

set (3 metal plates

and 6 rubber pads)

Strain relief