Instructions / Assembly

Assembly
3
6
Installing the casters
□
□
□
□
Mount the two swivel casters with brake (F) to the bottom of
the tray (I) using four bolts (CC) and washers (BB) per caster.
The swivel casters with brake (F) should be installed on the
Mount the two rigid casters (H) to the tray (I) using four bolts (CC)
and washers (BB) per caster.
Tighten all bolts (CC) with a 13 mm wrench.
Carefully return the tool cart to its upright position.
same side as the handle (D).
CAUTION: Do not over tighten the bolts.
1
Installing the legs
2
I
F
CC
BB
H
□ Place the tray (I) on its side on top of the packaging material while
mounting casters to protect the product`s finish.
□ Mount the four support legs (G) to the tray (I) using two
NOTE: Do not fully tighten bolts yet to allow for some
movement during cabinet installation.
Installing the cross supports, front rail
AA
AA
G
N
screws (AA) per leg. Finger tighten only.
□
Attach the pegboard (N) to the legs of the cart using six screws (AA).
Do not fully tighten screws at this time.
4
Installing the pegboard
NOTE: The pegboard is designed to attach to either
the left or right side of the tool cart, according to your
preference.
I
AA
L
E
□ Attach the left cross support (E) as shown using two screws (AA).
□ Attach the front rail (L) to the legs as shown with two screws (AA).
and bottle/can tray
□ Attach the right cross support (E) and bottle/can tray (O) to the
legs using two screws (AA). Do not over tighten.
E
O
AA
Do not fully tighten screws at this time.
Do not fully tighten screws at this time.