User manual

7.5 Rear spacers
• Install the spacers provided within the
accessory bag as shown in the figure.
• Install the spacers on the brackets of
the condenser (black grill) at the back
of the appliance.
7.6 Connecting the water
hose.
Water supply should be provided with a
tap and 3/4" male connector within 1,5
m from the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
The safety valve provided in a package
inside the appliance should be used to
prevent overflow.
Before the safety valve is placed on the
tap, turn the pointer clockwise to num-
ber 10 with the enclosed plastic key.
Install the safety valve on the tap and let
at least 10 litres of water flow through
the device.
Before connecting the appliance turn
the pointer to number 1 on the safety
valve.
If the safety valve has shut off, detach it
and press the red plunger which is loca-
ted inside the lower housing of the de-
vice itself.
Before the appliance is placed in final lo-
cation, ensure that the water connection
has been correctly carried out and that
there is no leakage at the connection to
the water tap.
Tighten the screw enough by hand.
Make sure that the gasket is properly
positioned in the connector.
We recommend that the appliance is
placed on a "run-off" mat intended for
refrigerators and freezers, which makes it
easier to detect possible leakage.
7.7 Levelling
When placing the appliance ensure that
it stands level. If necessary adjust the
feet using the adjustment spanner sup-
plied.
ENGLISH 17