User manual

WARNING!
Make sure that the temperature is more than 0 °C before you use the appliance again.
The manufacturer is not responsible for damages caused by low temperatures.
TROUBLESHOOTING
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the service
centre.
With some problems, the acoustic signals operate and the display shows an alarm code:
•
- The appliance does not fill with water.
•
- The appliance does not drain the water.
•
- The appliance door is open or not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before you do the checks.
Problem Possible cause Possible solution
The appliance does not
fill with water.
The water tap is closed. Open the water tap.
The water inlet hose is dam-
aged.
Make sure that the water inlet hose has
no damages.
The filters in the water inlet
hose is blocked .
Clean the filters. Refer to 'Care and
cleaning'.
The water tap is blocked or is
furred with limescale.
Clean the water tap.
The connection of the water
inlet hose is not correct.
Make sure that the connection is cor-
rect.
The water pressure is too low. Contact your local water authority.
The appliance does not
drain the water.
The water drain hose is dam-
aged.
Make sure that the water drain hose has
no damages.
The filter of the drain pump is
blocked.
Clean the filter of the drain pump. Refer
to 'Care and cleaning'.
The connection of the water
drain hose is not correct.
Make sure that the connection is cor-
rect.
A washing programme with-
out the drain phase is set.
Set the drain programme.
The function Rinse & Hold is
on.
Set the drain programme.
The appliance door is
open or not closed cor-
rectly.
Close the door correctly.
24 Troubleshooting