User manual

Problem Possible cause Possible solution
Incorrect temperature was set. Make sure that you set the correct tem-
perature.
Too much laundry load. Decrease the laundry load.
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the problem occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
TECHNICAL DATA
Dimensions Width / Height / Depth 600 / 850 / 605 mm
Total depth 640 mm
Electrical connection: Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles and moisture
ensured by the protective cover, except where the low voltage
equipment has no protection against moisture
IPX4
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum load Cotton 8 kg
Spin speed Maximum 1400 rpm (QW 148480)
1600 rpm (QW 168480)
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
INSTALLATION
Unpacking
1. Use the gloves. Remove the external
film. If necessary, use a cutter.
26 Technical data