Manual

Assembly
ASSEMBLY
IMPORTANT: Read entire owner's manual before you
attempt to assembleor operate your new pressure washer.
Remove Pressure Washer From
Carton
• Remove the high pressure hose, handle, and parts box
includedwith pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down fiat, then
remove all packing material.
• Roll pressure w_her out of carton.
Carton Contents
Items in the carton include:
Main unit
High pressure hose
Spray gun with quick connect fitting
Nozzle extension with quick connect fitting
Handle
Engineoil
Safety goggles
Parts Bag(includes the following):
Owner's registration card
Bagcontaining 5 multi-colored quick connect
spray tips
Maintenance kit
Owner's manual
Enginemanual
Enginewarranty card
Emissionscontrol warranty card
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
If any of the above parts are missing or damaged,call the
pressure washer helpline at 1-877-224-0458.
PREPARING PRESSURE
WASHER FOR USE
If you haveany problems with the assemblyof your
pressure washer or if parts are missing or damaged,call the
pressure washer helpline at 1-877-224-0458.
To prepare your pressure washer for operation_ you
will need to perform these tasks:
I. Fill out and send in registration card.
2. Attach handle to main unit.
3. Add oil to engine.
4. Add fuel to fuel tank.
5. Remove and discard tape from pump's oil filler cap.
6. Connect high pressure hoseto spraygun and pump.
7. Connect water supply to pump.
8. Connect nozzle extension to spray gun.
9. Select and installdesired quick connect spray tip.
Attach Handle
I. Place handle assemblyonto handte supports connected
to main unit. Make sure holes in handle alignwith
holes on handle supports (Figure I).
Handle
Supports
NOTE: It may be necessaryto move the handle supports
from side to side in order to alignthe handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob on insideof handles (Figure 2).
Tighten by hand.
3. Insert multi-colored spray tips in spacesprovided in
handle.