Operators Manual

500 m
2
/ 43 ≈ 12 h.
5400 ft
2
/ 463 ≈ 12 h.
Days /
week
h / day Timer settings
7 12 07:00-19:00 / 7:00
am-7:00 pm
3.10.3.3 To reset the timer setting
You can remove all timer settings and use the
factory setting. The factory timer setting lets the
product operate all hours each day of the week.
Refer to Timer and Standby on page 29 .
1. Do steps 1–3 in To get access to the menu
on page 23
.
2. Use the multi-choice buttons to move
through the menu structure Timer > Reset
timer
.
3. Push OK .
3.10.4 Installation
In the Installation menu it is possible to
adapt the settings of the product for
best mowing result.
3.10.4.1 Guide width
The guide width is a measure of how far from the
guide wire the product is allowed to travel when it
follows this to and from the charging station. The
area beside the wire which the product uses is
called the Corridor.
The product has a default setting for
Medium
wide corridors. To further reduce the risk of
tracks forming, it is recommended to select as
wide corridor as possible. The
Narrow corridor
setting is not normally recommended, but in a
garden with one or many narrow passages, a
narrow corridor may be the only option. The
Narrow corridor setting increases the risk for
tracks forming along the guide.
To set the guide width
1. Do steps 1–3 in
To get access to the menu
on page 23 .
2. Use the multi-choice buttons to move
through the menu structure to select
Installation > Guide width .
3. Use the multi-choice buttons to select
Narrow, Medium or Wide .
4. Push
OK .
3.10.4.2 Remote start 1
The Remote start function is used to guide the
product to remote parts of the work area. If the
work area includes areas that are connected with
narrow passages, the
Remote start function is
useful to be able to maintain a well-cut lawn in all
parts of the yard. The product begins to mow
when it reaches the
Remote start point. At all
other times, the product leaves the charging
station in the standard manner and starts to mow.
To set the Remote start function
1. Do steps 1–3 in To get access to the menu
on page 23 .
2. Use the multi-choice buttons to move
through the menu structure to select
Installation > Remote start > Proportion .
3. Select how often the Remote start function
shall be used. There are 5 options:
• Never (0%)
• Rarely (approx. 20%)
• Medium (approx. 50%)
• Often (approx. 80%)
• Always (100%)
4. Select the distance from the charging station
to the
Remote start .
5. Push OK .
3.10.4.3 Remote start 2
If the work area contains 2 remote areas, the
guide wire should be installed so that it reaches
both areas.
Remote start 1 and Remote start 2
can then be combined to steer the product to
each area.
24
- Installation
1285 - 004 - 16.04.2020