Operators Manual

The settings for Proportion and Distance are
carried out in the same way as for Remote start
1 . The factory setting is Never .
Note: The sum of
Proportion for Remote start 1
and Remote start 2 cannot exceed 100%.
If you have for instance selected Often for
Remote start 1 , then you can only select Never or
Rarely for Remote start 2 .
To measure the distance from the charging
station
1. Put the product in the charging station.
2. Do steps 1–3 in
To get access to the menu
on page 23 .
3. Use the multi-choice buttons to move
through the menu structure
Installation >
Remote start 1 or Remote start 2 >
Distance
.
4. Use the number buttons to set 100 m as a
distance.
5. Push
OK .
6. Use the multi-choice buttons to move
through the menu structure
Installation >
Test settings > Test OUT .
7. Push OK .
8. Push the STOP button when the product is
at the distance you select to measure. The
distance shows in the display.
3.10.4.4 Test settings
In the
Test settings menu, it is possible to test
how the settings for Remote start 1 and Remote
start 2
work in the work area in question.
To do a test of the Remote start function
1. Put the product in the charging station.
2. Do steps 1-3 in To get access to the menu
on page 23
.
3. Use the multi-choice buttons to move
through the menu structure
Installation >
Test settings > Test OUT > Remote start 1
or Remote start 2 .
4. Push
OK .
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.10.4.5 To set the Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting is 25 cm. You can select a
distance of 20-30 cm.
1. Do steps 1–3 in
To get access to the menu
on page 23 .
2. Use the multi-choice buttons to move
through the menu structure
Installation >
Drive Past Wire .
3. Use the number buttons to set the distance
in cm.
4. Push the BACK button.
3.10.5 Security level
There are 3 security levels for the product.
Function Low Medium High
Alarm X
PIN request X X
Time lock X X X
• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
•
PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for
some time. The lock is extended for each
new incorrect try.
•
Time lock - The product is locked if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
3.10.5.1 To change the PIN code
1. Do steps 1–3 in
To get access to the menu
on page 23 .
2. Use the multi-choice buttons to move
through the menu structure
Security >
Change PIN code
.
3. Enter the new PIN code.
1285 - 004 - 16.04.2020
Installation - 25