Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- To do the product settings
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
Message Cause Action
Empty battery
The product cannot find the charging
station.
Change the position of the guide wire.
Refer to
To install the guide wire on
page 21
.
The battery is spent. Replace the battery. Refer to
Battery
on page 32
.
The charging station’s antenna is de-
fective.
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 40
.
The charging plates on the product or
contact plates on the charging station
are corroded.
Clean the charging and contact plates
using a fine grade emery cloth. If the
problem stays speak to your authorized
service technician.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for a period of
time.
Enter the correct PIN code. Contact
Husqvarna
®
customer service if you
forget the PIN code.
No drive
The product has got caught in some-
thing and has been slipping.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
The work area includes a steep slope. Steep slopes should be isolated. Refer
to
To examine where to put the boun-
dary wire on page 15
.
The guide wire is not laid diagonally in
the slope.
Make sure that the guide wire is instal-
led diagonally across the slope. Refer
to
To examine where to put the guide
wire on page 18
.
Wheel motor over-
loaded, left/right
Grass or other object is wrapped
around the drive wheel.
Check the drive wheel and remove
grass or object.
Collision sensor
problem, rear
The product body can not move freely
around its chassis.
Check that the product body can move
freely around its chassis. If the problem
stays speak to your authorized service
technician.
Alarm! Mower
switched off
The alarm is activated because the
product had been switched off.
Adjust the security level in the
Security
menu. Refer to
Security level on page
25
.
Alarm! Mower
stopped
The alarm is activated because the
product has been stopped.
Alarm! Mower lif-
ted
The alarm is activated because the
product has been lifted.
Alarm! Mower til-
ted
The alarm is activated because the
product has been tilted.
1285 - 004 - 16.04.2020 Troubleshooting - 35