Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- To do the product settings
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
Message Cause Action
Charging station
blocked
The contact between the charging
plates on the product on the and con-
tact plates on the charging station may
be poor and the product has made a
number of attempts to charge.
Put the product in the charging station
and check that the charging plates and
contact plates make good contact.
An object is in the way of the product
that prevents it to enter the charging
station.
Remove the object.
The charging station is tilted or bent. Put the baseplate on level ground.
The guide wire is not installed correctly. Check if the guide wire is installed ac-
cording to the instructions. Refer to
To
install the guide wire on page 21
.
Stuck in charging
station
There is an object in the way of the
product preventing it from leaving the
charging station.
Remove the object.
Upside down
The product is leaning too much or has
turned over.
Turn the product the right way up.
Needs manual
charging
The product is set to the
MAN
operat-
ing mode.
Put the product in the charging station.
Next start hh:mm
The timer setting prevents the product
from operating.
Change the timer settings. Refer to
To
do the timer settings on page 23
.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
This behavior is normal and no action
is required.
The clock or date in the product is not
correct.
Set the time. Refer to
To set the Time
& Date on page 26
.
Today's mowing
completed
The product has an inbuilt standby peri-
od according to the Standby time table.
This behavior is normal and no action
is required. Refer to
Timer and Standby
on page 29
.
Lifted
The lift sensor has been activated as
the product has been lifted.
Check that the product body can move
freely around its chassis. Remove or
create an island around objects that
can cause the chassis to be lifted. If the
problem stays speak to your authorized
service technician.
Wheel drive prob-
lem, right/left
Grass or other object is wrapped
around the drive wheel.
Clean the wheels and around the
wheels.
36 - Troubleshooting 1285 - 004 - 16.04.2020