Operators Manual

Message Cause Action
Electronic problem Temporary electronic or firmware rela-
ted issue in the product.
Restart the product. If the problem
stays speak to your authorized service
technician.
Loop sensor prob-
lem, front/rear
Tilt sensor prob-
lem
Temporary prob-
lem
Invalid sub-device
combination
Temporary battery
problem
Charging system
problem
Incorrect type of battery. Use original batteries recommended by
the manufacturer.
Battery problem Temporary battery or firmware related
issue in the product.
Restart the product. If the problem
stays speak to your authorized service
technician.
Incorrect type of battery. Use original batteries recommended by
the manufacturer.
Battery tempera-
ture outside limits
The temperature in the battery is too
high or too low to start operation.
No action. The product will start to op-
erate when the temperature is in limits.
Charging current
too high
Wrong or faulty power supply unit. Restart the product. If the problem
stays speak to your authorized service
technician.
Connectivity prob-
lem
Potential problem on the connectivity
circuit board in the product.
Restart the product. If the problem
stays speak to your authorized service
technician.
Connectivity set-
tings restored
The connectivity settings was restored
due to a fault.
Check and change the settings if nee-
ded.
Poor signal quality The connectivity circuit board in the
product is assembled upside down, or
the product itself is tilted or upside
down.
Make sure that the product is not up-
side down or tilted. If the problem stays
speak to your authorized service tech-
nician.
1285 - 004 - 16.04.2020
Troubleshooting - 37