Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- To do the product settings
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
Message Cause Action
No loop signal
The power supply or low-voltage cable
is not connected.
If the LED status indicator on the
charging station is not lit, it shows that
there is no power. Examine the power
outlet connection and the residual-cur-
rent device. Make sure that the low-
voltage cable is connected to the
charging station.
The power supply or low-voltage cable
is damaged or not connected.
Replace the power supply or low-volt-
age cable.
The boundary wire is not connected to
the charging station.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Replace connectors if dam-
aged. Refer to
To install the boundary
wire on page 20
.
The boundary is wire broken. Do a check of the LED status indicator
on the charging station. If it shows
break in the boundary wire, replace the
damaged section with a new loop wire
and splice using an original coupler.
ECO mode
is activated and the product
has attempted to start outside the
charging station.
Put the product in the charging station,
start the product and close the hatch.
The boundary wire is crossed on its
way to and from an island.
Check that the boundary wire is laid ac-
cording to instructions, e.g. in the right
direction around the island. Refer to
To
install the boundary wire on page 20
.
The pairing between the product and
the charging station is lost.
Put the product in the charging station
and generate a new loop signal. Refer
to
To create a New loop signal on page
26
.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
Try to move the boundary wire and/or
make islands in the work area to in-
crease the signal strength.
The product is too far from the boun-
dary wire.
Redo the installation of the boundary
wire so that all parts of the work area is
maximum 15 m / 50 ft. from the boun-
dary wire.
Mower tilted
The product is tilted more than the
maximum angle.
Move the product to a flat area.
Connection NOT
changed
Failed to change loop signal. Try to create a
New loop signal
several
times. Refer to
To create a New loop
signal on page 26
. If the problem stays
speak to your authorized service tech-
nician.
38 - Troubleshooting
1285 - 004 - 16.04.2020