Operators Manual

7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
7.2 Storage
• Fully charge the product. Refer to
To charge
the battery on page 30
.
• Switch off the product. Refer to
To switch off
the product on page 29 .
• Clean the product. Refer to
Clean the
product on page 31 .
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level
ground during storage, or use an original
wall hanger if available.
• If you keep the charging station indoors,
disconnect and remove the power supply
and all the connectors from the charging
station. Put the end of each connector wire
in a container with grease.
Note:
If you keep the charging station outdoors,
do not disconnect the power supply and the
connectors.
7.3 Disposal
• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the
battery, refer to
To remove the battery on
page 45 .
7.3.1 To remove the battery
Follow these steps for removal of the battery from
the product.
1. Set the Main switch in position 0 .
2. Set the cutting height to its lowest position.
3. Turn the product upside down.
4. Clean around the battery cover.
5. Remove the 4 screws to the battery cover
(Torx 20) and remove the battery cover.
6. Remove the screw of the battery retaining
bracket and remove the bracket.
7. Pull out the battery by pulling on the strap.
1285 - 004 - 16.04.2020 Transportation, storage and
disposal - 45