Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Before the installation of the wires
- Before the installation of the product
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To change the position of the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- To do the product settings
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- Applicable to US/CA market
5. Use the arrow buttons to set the time
format and then push the BACK button.
6. Use the arrow buttons to set the date
format and then push the BACK button.
3.10.10.2 To set the language
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> General > Language.
3. Use the arrow buttons to select language
and then push the BACK button.
3.10.10.3 To set the country
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> General > Country.
3. Use the arrow buttons to select country
and then push the BACK button.
3.10.10.4 To reset all user settings
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> General > Reset all user settings
.
3. Use the right arrow button to select
Proceed with reset of all user settings?
4. Push the OK button to reset all the user
settings.
Note:
Security level, PIN code, Loop signal,
Messages, Date & Time, Language
and
Country
settings
are not reset.
3.10.10.5 The About menu
The
About
menu displays information about the
product, for example serial number and software
versions.
982 - 001 - 12.12.2018
Installation - 25