Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Before the installation of the wires
- Before the installation of the product
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To change the position of the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- To do the product settings
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- Applicable to US/CA market
10. Place the battery holder (including the
battery) back into place in the product.
11. Connect the cable
12. Fit the battery cover without clamping the
cables. If the seal on the battery cover is
visibly damaged, the entire battery cover
must be replaced.
13. Carefully cross-tighten the 4 screws for the
battery cover (Torx 20).
5.6 Winter service
Take your product to your local Husqvarna
representative for service prior to winter storage.
Regular winter service will maintain the product in
good condition and create the best conditions for
a new season without any disruptions.
Service usually includes the following:
• Thorough cleaning of the body, the chassis,
the blade disc and all other moving parts.
• Testing of the products’s function and
components.
• Checking and, if required, replacing wear
items such as blades and bearings.
• Testing the products’s battery capacity as
well as a recommendation to replace battery
if necessary.
• If new software is available, the product is
updated.
32
- Maintenance
982 - 001 - 12.12.2018