Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Before the installation of the wires
- Before the installation of the product
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To change the position of the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- To do the product settings
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- Applicable to US/CA market
Message Cause Action
No drive
The product has got caught in some-
thing.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
The work area includes a steep slope. Steep slopes should be isolated. Refer
to
To examine where to put the guide
wire on page 17
.
The guide wire is not laid at an angle
on a slope.
If the guide wire is laid on a slope, it
must be laid at an angle across the
slope. Refer to
To examine where to
put the guide wire on page 17
.
Wheel motor over-
loaded, right
The product has got caught in some-
thing.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Wheel motor over-
loaded, left
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and the product has made a number of
attempts to charge.
Put the product in the charging station
and check that the charging strips and
contact strips make good contact.
An object is obstructing the product. Remove the object.
The charging station is tilted or bent. Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not
be tilted or bent.
Stuck in charging
station
There is an object in the way of the
product preventing it from leaving the
charging station.
Remove the object.
Upside down
The product is leaning too much or has
turned over.
Turn the product the right way up.
Needs manual
charging
The product is set to the
Secondary
area
operating mode.
Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
Next start hh:mm
The schedule setting prevents the
product from operating.
Change the schedule settings. Refer to
To do the schedule settings on page
20
.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
This behavior is normal and no action
is required.
The clock on the product is not correct. Set the time. Refer to
To set the time &
date on page 24
.
36 - Troubleshooting 982 - 001 - 12.12.2018