Operators Manual

Message Cause Action
Today's mowing
completed
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
This behavior is normal and no action
is required.
Lifted The lift sensor has been activated as
the product has become trapped.
Free the product.
Collision sensor
problem, front/rear
Product body can not move freely
around its chassis.
Check that the product body can move
freely around its chassis.
If the problem remains, the message
requires action by authorized service
technician.
Wheel drive prob-
lem, right/left
Grass or other object is wrapped
around the drive wheel.
Clean the wheels and around the
wheels.
Safety function
faulty
Temporary electronic or software rela-
ted issue in the product.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Electronic problem
Loop sensor prob-
lem, front/rear
Charging system
problem
Tilt sensor prob-
lem
Temporary prob-
lem
Temporary battery
problem
Temporary battery or software related
issue in the product.
Restart the product.
Disconnect and reconnect the battery.
If the problem remains, the message
requires action by authorized service
technician.
Battery problem
Charging current
too high
Wrong or faulty power supply unit. Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Connectivity prob-
lem
Potential problem on the connectivity
circuit board in the product.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Connectivity set-
tings restored
The connectivity settings was restored
due to a fault.
Please check and change the settings
if needed.
982 - 001 - 12.12.2018 Troubleshooting - 37