Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Before the installation of the wires
- Before the installation of the product
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To change the position of the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- To do the product settings
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- Applicable to US/CA market
1.7 Display
The display on the product shows information
and settings of the product.
To access the display, push the STOP button.
1.8 Keypad
The keypad consists of 6 groups of buttons:
OK
1
2
3
5
4
6
1. The
ON/OFF button is used to turn the
product ON/OFF. The indicator lamp on the
ON/OFF button is an important status
indicator. Refer to
The indicator lamp on
page 26
.
2. The Start button is used to start the
operation of the product.
3. The Menu button is used to go to the main
menu.
Note:
The Menu button is also used as a
Back button, that is, when moving back up
in the menu lists.
4. The Mode button is used to choose
operating mode, for example,
Main area
or
Park
.
5. The OK button is used to confirm the
chosen settings in the menus.
6. The arrow keys are used to navigate in the
menu. The up/down arrow keys are also
used to enter digits, for example, PIN code,
time and date
8
- Introduction
982 - 001 - 12.12.2018