Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Cutting equipment
- Specification of bar and saw chain
- Sharpening your chain and adjusting raker clearance
- Tensioning the saw chain
- Lubricating cutting equipment
- Checking wear on cutting equipment
- Safety instructions for using a pruning saw
- Fitting the cutting head
- Fitting the bar and chain
- Assembling the guard
- Fitting the suspension ring
- Adjusting the harness
- Filling with oil
- Check before starting
- Technical data
- Guide bar and saw chain combinations
- EC Declaration of Conformity (Applies to Europe only)
- Simboli
- Indice
- Prima dell’avviamento osservare quanto segue:
- Alla gentile clientela
- Attrezzatura di taglio
- Specifiche relative a lama e catena
- Affilatura della catena e controllo della profondità di taglio
- Tensionamento della catena
- Lubrificazione dell’attrezzatura di taglio
- Controllo dell’usura dell’attrezzatura di taglio
- Norme di sicurezza per l’uso di motosega ad asta
- Montaggio testina di taglio
- Montaggio di lama e catena
- Montaggio della protezione.
- Montaggio del gancio di sospensione
- Impostazione dell’imbracatura
- Rabbocco dell’olio
- Controlli prima dell’avviamento
- Caratteristiche tecniche
- Combinazioni di lama e catena
- Dichiarazione di conformità CE (Solo per l’Europa)
ASSEMBLY
English – 15
Fitting the cutting head
• Loosen the screw on the cutting head. (A)
• Fit the cutting head on the shaft so that the screw (A)
is aligned with the hole in the shaft as shown.
• Screw in screw A finger tight. Make sure that screw A
fits into the hole in the shaft.
• Tighten screw A.
• Tighten screw B.
CAUTION! Make sure that the drive shaft inside the shaft
engages with the cut-out in the cutting head.
Fitting the bar and chain
• Unscrew the bar nut and remove the protective cover.
• Fit the bar over the bar bolt. Place the bar in its
rearmost position. Place the chain over the drive
sprocket and in the groove on the bar. Begin on the
top side of the bar.
• Make sure that the edges of the cutting links are
facing forward on the top edge of the bar.
• Fit the cover and locate the chain adjuster pin (A) in
the hole in the bar. Check that the drive links of the
chain fit correctly on the drive sprocket (B) and that
the chain is in the groove in the bar (C). Tighten the
bar nut finger-tight.
• Tension the chain by turning the chain tensioning
screw clockwise using the combination spanner. The
chain should be tensioned until it does not sag from
the underside of the bar.
• The chain is correctly tensioned when it does not sag
from the underside of the bar, but can still be turned
easily by hand. Hold up the bar tip and tighten the bar
nuts with the combination spanner.
• When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check the
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life.
Assembling the guard
• Assemble the guard on the shaft. Make sure the guard
is assembled adjacent to the saw head.
• Secure the guard to the shaft with the screw.
A
B
A
B