Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Cutting equipment
- Specification of bar and saw chain
- Sharpening your chain and adjusting raker clearance
- Tensioning the saw chain
- Lubricating cutting equipment
- Checking wear on cutting equipment
- Safety instructions for using a pruning saw
- Fitting the cutting head
- Fitting the bar and chain
- Assembling the guard
- Fitting the suspension ring
- Adjusting the harness
- Filling with oil
- Check before starting
- Technical data
- Guide bar and saw chain combinations
- EC Declaration of Conformity (Applies to Europe only)
- Simboli
- Indice
- Prima dell’avviamento osservare quanto segue:
- Alla gentile clientela
- Attrezzatura di taglio
- Specifiche relative a lama e catena
- Affilatura della catena e controllo della profondità di taglio
- Tensionamento della catena
- Lubrificazione dell’attrezzatura di taglio
- Controllo dell’usura dell’attrezzatura di taglio
- Norme di sicurezza per l’uso di motosega ad asta
- Montaggio testina di taglio
- Montaggio di lama e catena
- Montaggio della protezione.
- Montaggio del gancio di sospensione
- Impostazione dell’imbracatura
- Rabbocco dell’olio
- Controlli prima dell’avviamento
- Caratteristiche tecniche
- Combinazioni di lama e catena
- Dichiarazione di conformità CE (Solo per l’Europa)
ASSEMBLY
16 – English
Fitting the suspension ring
Fit the suspension ring between the rear handle and the
loop handle. Position the hanging ring so that the machine
is balanced and comfortable to work with.
Adjusting the harness
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back.
• Put on the harness.
• Hook the machine onto the harness support hook.
• Adjust the length of the harness so that the support
hook is roughly level with your right hip.
Filling with oil
• Open the cap on top of the bar head
• Fill with Husqvarna saw chain oil.
• Refit the cap.
Check before starting
• Inspect the working area. Remove any objects that
could be thrown out.
• Check the cutting attachment. Never use blunt,
cracked or damaged equipment.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Make sure the chain is adequately lubricated. See
instructions under the heading Lubricating the cutting
attachment.
• Check that the cutting attachment always stops when
the engine is idling.
• Only use the machine for the purpose it was intended
for.
• Make sure the handle and safety features are in order.
Never use a machine that has any parts missing or
has been modified in relation to the specification.