Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Cutting equipment
- Specification of bar and saw chain
- Sharpening your chain and adjusting raker clearance
- Tensioning the saw chain
- Lubricating cutting equipment
- Checking wear on cutting equipment
- Safety instructions for using a pruning saw
- Fitting the cutting head
- Fitting the bar and chain
- Assembling the guard
- Fitting the suspension ring
- Adjusting the harness
- Filling with oil
- Check before starting
- Technical data
- Guide bar and saw chain combinations
- EC Declaration of Conformity (Applies to Europe only)
- Simboli
- Indice
- Prima dell’avviamento osservare quanto segue:
- Alla gentile clientela
- Attrezzatura di taglio
- Specifiche relative a lama e catena
- Affilatura della catena e controllo della profondità di taglio
- Tensionamento della catena
- Lubrificazione dell’attrezzatura di taglio
- Controllo dell’usura dell’attrezzatura di taglio
- Norme di sicurezza per l’uso di motosega ad asta
- Montaggio testina di taglio
- Montaggio di lama e catena
- Montaggio della protezione.
- Montaggio del gancio di sospensione
- Impostazione dell’imbracatura
- Rabbocco dell’olio
- Controlli prima dell’avviamento
- Caratteristiche tecniche
- Combinazioni di lama e catena
- Dichiarazione di conformità CE (Solo per l’Europa)
KEY
T
O SYMBOLS
2
–
English
Symbols
W
ARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or
fatal injury to the operator or others.
Please read the operator’s manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• A protective helmet where there is a
risk of falling objects
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with
applicable EC directives.
This machine is not electrically
insulated. If the machine
touches or comes close to high-
voltage power lines it could lead
to death or serious bodily injury.
Electricity can jump from one
point to another by arcing. The
higher the voltage, the greater
the distance electricity can
jump. Electricity can also travel
through branches and other
objects, especially if they are wet. Always keep a distance
of at least 10 m between the machine and high-voltage
power lines and/or any objects that are touching them. If
have to work within this safe distance you should always
contact the relevant power company to make sure the
power is switched off before you start work. This machine
has a long reach. Make sure that no people or animals
come closer than 15 m when the machine is running.
Other symbols/decals on the mac
hine refer to special
certification requirements for certain markets.
Always wear approved protective
gloves.
Wear sturdy, non-slip boots.
Switch off the engine by moving the
stop switch to the STOP position
before carrying out any checks or
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Filling with chain oil and adjusting oil
flow