Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Cutting equipment
- Specification of bar and saw chain
- Sharpening your chain and adjusting raker clearance
- Tensioning the saw chain
- Lubricating cutting equipment
- Checking wear on cutting equipment
- Safety instructions for using a pruning saw
- Fitting the cutting head
- Fitting the bar and chain
- Assembling the guard
- Fitting the suspension ring
- Adjusting the harness
- Filling with oil
- Check before starting
- Technical data
- Guide bar and saw chain combinations
- EC Declaration of Conformity (Applies to Europe only)
- Simboli
- Indice
- Prima dell’avviamento osservare quanto segue:
- Alla gentile clientela
- Attrezzatura di taglio
- Specifiche relative a lama e catena
- Affilatura della catena e controllo della profondità di taglio
- Tensionamento della catena
- Lubrificazione dell’attrezzatura di taglio
- Controllo dell’usura dell’attrezzatura di taglio
- Norme di sicurezza per l’uso di motosega ad asta
- Montaggio testina di taglio
- Montaggio di lama e catena
- Montaggio della protezione.
- Montaggio del gancio di sospensione
- Impostazione dell’imbracatura
- Rabbocco dell’olio
- Controlli prima dell’avviamento
- Caratteristiche tecniche
- Combinazioni di lama e catena
- Dichiarazione di conformità CE (Solo per l’Europa)
SAFETY INSTR
UCTIONS
8
–
English
2
Cutting angle
3 File position
4 Round file diameter
5 File depth
It is very difficult to sharpen a chain correctly without the
right equipment. We recommend that you use our file
gauge. This will help you obtain the maximum kickback
reduction and cutting performance from your chain.
Sharpening cutting teeth
•
To sharpen cutting teeth you will need a round file and
a file gauge.
• Check that the chain is correctly tensioned. A slack
chain will move sideways, making it more difficult to
sharpen correctly.
• Always file cutting teeth from the inside face outwards.
Reduce the pressure on the return stroke. File all the
1
5
!
W
ARNING! The following faults will
increase the risk of kickback
considerably: File angle too large
Cutting angle too small
File diameter too small