Operators Manual

To do a check of the saw chain lubrication
Do a check of the chain saw lubrication each time you
refuel.
1. Start the product and let it run at 3/4 speed. Point the
nose of the guide bar at a light color surface almost
20 cm (8 in) away.
2. After 1 minute of running, a line of oil shows on the
light surface.
3. If you cannot see the line of oil after 1 minute, clean
the oil channel in the guide bar. Clean the groove in
the edge of the guide bar. Make sure the guide bar
nose sprocket turns freely and that there are no
blockages in the lubrication hole. Clean and lubricate
the tip sprocket.
4. Start the product and let it run at 3/4 speed. Point the
nose of the bar at a light color surface almost 20 cm
(8 in) away.
5. After 1 minute of running, a line of oil shows on the
light surface.
6. If you cannot see the line of oil after 1 minute, speak
to your approved dealer.
Transportation
• Put the transportation guard on the cutting
attachment during transportation to prevent injuries.
• Make sure that the product can not move during
transportation.
Storage
• Always put the product away safely when not in
operation. Leakages and fumes from the product can
touch sparks, naked flames from electrical
equipment, electrical mowers, relays/switches,
boilers and more.
• Always save fuel in an approved container.
• Empty the fuel tank and the chain oil tank when the
product is in storage for longer periods of time.
Discard used fluids correctly.
• Put the transportation guard on the cutting
attachment during storage to prevent injuries.
• Remove the spark plug cap from the spark plug and
engage the chain brake before storage.
Technical data
unit
120e Mark II
(P02138HV)
Engine specifications
Cylinder displacement cm
3
38
Spark plug Champion RCJ7Y
Electrode gap mm (in) 0,5 (0.02)
Fuel tank volume cm
3
300
Idle speed min
-1
2800-3200
Power output at 9000 min
-1
kW 1,4
Emission durability period h 125
Noise and vibration data
Equivalent vibration levels, a
hveq
front handle
1
m/s
2
5,3
1
Equivalent vibration level, according to ISO 22867, is calculated as the time-weighted energy total for vibration
levels under various working conditions. Reported data for equivalent vibration level has a typical statistical
dispersion (standard deviation) of 1 m/s
2
.
24 653 - 007 - 06.05.2020