Operators Manual

18 – English
Assembling guard and trimmer head
(142R)
• Fit the guard (A) to the
gear housing using the
support plate (M) and two
screws (L).
• Fit the disc drive (B) on
the output axle.
• Turn the blade axle until
one of the disc drive’s
holes aligns with the
corresponding hole in the
gear housing.
• Insert the locking pin (C)
into the hole to lock the
axle.
• Screw on the trimmer
head (H) in the direction
of rotation.
• Dismantling takes place in
the reverse order.
M
L
A
ASSEMBLY
• 132R: The guard (A) is
fitted using 4 screws (L) as
set out in the diagram.
NOTE! Use the
recommended blade guard.
• 142R: Fit the guard (A) to
the gear housing using the
support plate (M) and two
screws (L). NOTE! Use the
recommended blade guard.
• Fit the drive disc (B) on the
output axle.
• Turn the blade axle until
one of the holes in the drive
disc aligns with the hole in
the gear housing.
• Insert the locking pin (C)
in the hole so that the axle
is locked.
• Place the blade (D),support
cup (F) and support flange
(E) on the output shaft.
• Fit the nut (G). The
tightening torque of the nut
is 35-50 Nm (3,5 - 5 kpm).
Use the socket spanner in
the tool kit. Hold the
handle of the spanner as
close to the blade guard as
possible. The nut is
tightened when the spanner
is turned against the
direction of rotation (left-
hand thread).
Assembling the blade guard and
grass blade
M
L
A
L
A
132R
142R
B
A
L
M
C
H
• Fit the guard (A)
intended for use with
the trimmer head.
Secure using four bolts
(L) and the support plate
(M) as shown in the
diagram.
• Fit the disc drive (B) on
the output axle.
• Turn the blade axle until
one of the disc drive’s
holes aligns with the
corresponding hole in
the gear housing.
• Insert the locking pin
(C) into the hole to lock
the axle.
• Screw on the trimmer
head (H) in the
direction of rotation.
• Dismantling takes place
in the reverse order.
Assembling guard and trimmer head
(132R)
G
F
D
B
C
E
G
E
D
B
C
F
H