Operation Manual

20 – English
MAINTENANCE
Troubleshooting schedule
Control panel
Troubleshooting takes place from the control panel.
Battery and battery charger
Troubleshooting the battery and/or the battery charger during charging.
LED display Possible faults Possible action
Error LED flashes.
Overload.
The cutting attachment is
jammed. Release the cutting
attachment.
Temperature deviation.
Allow the machine to cool
down.
The power trigger and the
activate button are pressed
at the same time.
Release the power trigger
and the machine is active.
Error LED is lit with red light. Non repairable fault. Contact your service agent.
LED display Possible faults Possible action
Error LED flashing.
Temperature
deviation.
Use the battery in surroundings
where temperatures are between -
10
°C and 40 °C.
Over voltage.
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Remove the battery from the battery
charger.
Error LED is lit.
Cell difference too
much (1V).
Contact your service agent.
H1154526-38,136 LiHD50,_1 v2.fm Page 20 Friday, February 10, 2012 3:20 PM