Operation Manual

STARTING AND STOPPING
English – 15
Check before starting
Remove the battery from the machine by pressing the two
release buttons and pulling out the battery.
• Inspect the working area. Remove any objects that
could be thrown out.
• Check the cutting attachment. Never use blades that
are dull, cracked or damaged.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Only use the machine for the purpose it was intended
for.
• Make sure that the handle and safety features are in
good working order. Never use a machine that lacks a
part or has been modified outside its specifications.
Gloves should be worn when necessary.
• All covers must be correctly fitted and undamaged
before you start the machine.
Connect battery to the machine
Make sure to use fully charged batteries. Use only a
Husqvarna original battery in your machine. See technical
data.
• Insert the battery in the machine. The battery should
slide easily into the battery holder on the machine. If
the battery does not slide in easily, it is not being
inserted correctly. The battery will lock itself into place
when you hear a click. Make sure the battery is fitted
correctly to the machine.
(Figure 13)
Starting and stopping
Starting
• Turn on the machine. Press and hold the start button
(>1 sec.) until the green LED is lit.
(Figure 14)
• Press the power trigger on the front handle. (Figure
15)
• Then press the power trigger on the rear handle up to
apply full power.
(Figure 16)
Stopping
• Stop the machine by releasing the power trigger on
the rear handle or the power trigger on the front
handle and deactivate the machine.
Remove the battery from the machine by pressing the two
release buttons and pulling out the battery.
(Figure 17)
!
WARNING! Make sure no unauthorised
persons are in the working area.
Otherwise there is a risk of serious
personal injury. The safety distance is 15
meters.
IMPORTANT! Always remove the battery to prevent the
machine being started by accident.