User Manual

Location of shipping spacer
Cutters
Bar Clamp/
Chain Brake
Bar Damp Nuts
Bar Tool
An adjusting pin and screw is used to ad
just the tension of the chain. It is very im
portant when assembling the bar, that the
pin located on the adjusting screw aligns
intoa hole in the bar. Turning the screw wili
move the adjustment pin up and down the
screw. Locate this adjustment before you
begin mounting the bar onto the saw. See
iilustration.
Adjustment located on Bar Clamp
Turn the adjusting screw counterclock
wise to move the adjusting pin almost as
far as it will go to the rear. This shouidallow
the pin to be nearthe correct position. Fur
ther adjustment may be necessary as you
mount the bar.
Mount the bar as iilustrated.
Mount the Bar
Slide guide bar behind clutch drum until
guide bar stops against clutch drumn
sprocket.
Carefully remove the chain from the pack
age. Hold chain with the drive links as
shown.
Drive Links
Place chain onto the sprocket
* Place chain over and behind clutch, fitting
the drive links in the clutch drum sprocket.
* Fit bottom of drive links between the teeth
in the sprocket in the nose of the guide bar.
* Fit chain drive links into bar groove.
* Pull guide barforward until chain is snug in
guide bar groove. Ensure all drive iinks
are in the bar groove.
* Now, instali chain brake making sure the
adjusting pin is positioned in the lower hole
in the guide bar. Remember this pin
moves the bar forward and backward as
the screw is turned.
* Install chain brake nuts and finger tighten
oniy. Once the chain is tensioned, you will
need to tighten chain brake nuts.
CHAIN TENSION (Including units with
chain already installed)
NOTE: When adjusting chain tension,
make sure the bar nuts are finger tight only.
Attempt! ngto tensionthe chain when the bar
nuts are tight can cause damage.
Checking the tension:
Use the screwdriver end of the combination
screwdriver/wrench tooi to move the chain
around the bar. If the chain does not rotate, it
is too tight. If too loose, the chain will sag be
low the bar.
Guide
Bar
Chain Brake Nuts
Chain Adjustment
Too! (Bar Tool)
Adjusting the tension:
Chain tension is very important. Chain
stretches during use. This is especially true
during the first few times you use your saw.
Always check chain tension each time you
use and refuel your saw.
You can adjust the chain tension by loosening
the bar clamp nuts and turning the adjusting
screw 1/4 of a turn while lifting up on the bar.
* If chain is too tight, turn adjusting
screw 1/4 turn counterclockwise.