Use and Care Guide

ASSEMBLY INSTRUCTIONS
Assemble Pump Handle
Slide handle onto shaft and line up holes. Thread bolt through handle
and shaft and securely tighten. Thread on lock nut and tighten using
a 13mm (or adjustable) wrench. Handle can be mounted on left or
right depending on user preference. (See Figure D)
Assemble Extension, Shut-O, Nozzle and Spray
Optimizer
1. Install the extension “wand” onto the shut-o
assembly and tighten the nut securely. (See Figure A)
2. (Optional) Install Spray Optimizer for low pressure (low
drift) applications. This will help prevent weed killer
formulas from drifting into undesired areas. (Do not
over tighten, actual position will vary. See Figure B)
3. Install selected nozzle onto the end of the extension
or optimizer (if installed) and tighten securely.
(See Figure C)
Figure A
Figure B
(Optional)
Figure C
Figure D
Folding Handle
1. Thread bolt through handle
and shaft as stated above.
2. Snap strap around
handle.
3. Handle shown in
folded position.
Page 3
SELECT NOZZLE FROM CHART BELOW
A. Cap Nut
B. Foaming Nozzle
C. Red High-Volume Fan Nozzle
D. Yellow Low-Volume Fan Nozzle
E. Adjustable Cone Nozzle
F. Flat Seal
G. Adapter
H. Extension
E
A
G
B
C
F
H
D
ADJUSTABLE CONE USES:
Spot spraying in or around flower
beds, trees, and shrubs.
Edging along fences, driveways,
and walkways.
Killing brush such as poison ivy,
poison oak, kudzu and wild
blackberry.
Preparing garden beds for
planting of ornamentals and
vegetables.
For precision spraying in
confined areas such as
gardens and flower beds.
FAN NOZZLE USES:
Lawn replacement. Kill lawn
and weeds before planting a
new lawn.
Preparing large areas for
planting of ornamental and
vegetable gardens.
RED HIGH VOLUME YELLOW LOW VOLUME
FAN NOZZLE USES:
FOAMING NOZZLE USES:
Spot spraying in flower beds,
walkways, driveways, and
patios, around trees and shrubs.
Edging along fences, driveways
and walkways.
Killing brush such as poison
ivy, poison oak, kudzu and wild
blackberry.