Owner's Manual

English - 13
2. PRESENTATION
Working method
Automower
®
automatically mows the lawn.
It continuously combines mowing and charging.
The mower starts to search for the charging station
when the battery charge becomes too low.
Automower
®
does not mow when it is searching for
the charging station.
When Automower
®
searches for the charging station,
it first searches irregularly for the guide wire. Then it
follows the guide wire to the charging station, turns
around just in front of the station and backs into it.
When the battery is fully charged, the mower leaves
the charging station and starts mowing in a randomly
selected direction within the 90˚ to 270˚ exit sector.
In order to ensure an even cut, even in parts of the
garden that are hard to reach, there are a number of
manual settings for how the mower is to leave the
charging station, see 6.4 Installation (2) .
When Automower
®
body hits an obstacle, the mower
reverses and selects a new direction.
Two sensors, one at the front and one at the back on
Automower
®
, sense when the mower approaches the
boundary wire. Automower
®
overruns the wire by up
to 11" (28 centimetres) before it turns.
The STOP button on the top of Automower
®
is mainly
used to stop the mower when it’s running. When the
STOP button is pressed a cover opens, behind which
there is a control panel. The STOP button remains
depressed until the cover is closed again. This acts
as start inhibitor.