Operators Manual

English - 23
3. INSTALLATION
• Make sure to lay the boundary wire tight to the ground
and secure the staples close together with
approximately 75 cm between each staple. The wire
must generally lie close to the ground so, as not to be
cut off before the grass roots have grown over it.
• Use a hammer to knock down the staples in the
ground. Exercise care when knocking in the staples
and make sure the wire is not under strain. Avoid
forming the wire in sharp bends.
If you intend to bury the boundary wire:
• Make sure to place the boundary wire at least 1 cm
and a maximum of 20 cm into the ground.
The boundary wire must be crossed on the path to
and from an island.
Laying the boundary wire in towards the loop
generator/charger
The ends of the boundary wire are
run in parallel and close to each
other in towards the loop
generator/charger. As long as the
total length of the boundary wire
does not exceed 350 m, the sections
where the wires run in parallel can
be any length. For example, it is
possible to place the loop
generator/charger inside the house
and run the boundary wire through a
window and out to the garden.
IMPORTANT INFORMATION
Pay particular attention not to cross the
boundary wire in towards the loop
generator/charger.